Hotpoint RFA52T (0) Instruções de Utilização Página 13

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 12
13
DOOR REVERSAL
Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug.
It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated containers
whilst carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original packaging).
Remove the doors
1. Lay down the appliance on its back.
2. Unscrew, remove and retain the bottom hinge.
3. Slightly open the bottom door and slide downward remove and carefully place to one side
4. Remove centre hinge and spacer if fitted. Slightly open the top door and slide downwards, remove and carefully place to
one side.
5. Unscrew and remove the top front cover from the cabinet .
6. Unscrew and remove the hinge pin and the bolt from the top right hand and refit them into the hole in the left hand side.
Refit the top front cover.
7. Use a thin blunt instrument
to remove the top and
bottom hinge bushes and
blanking plugs from the
doors, take care not to
mark the door handle.
Reposition the blanking
plugs and bushes on the
opposite side.
8. Fit the blanking plugs
provided into the right hand
two centre hinge holes.
Replacing the doors
1. Slide the top door upwards and locate the top hinge pin into the door brush. Reposition the centre hinge on the opposite
side.
2. Carefully slide bottom door upward into
the centre hinge pin.
3. Unscrew the bottom hinge pin and refit
it on the opposite side..
4. Fit the bottom hinge making sure that
the door is aligned to the cabinet.
5. Carefully stand the appliance upright in
its required location and make sure it
is sitting level on the floor. Open and
close the doors checking that the gasket
makes a good seal without any gaps
when the doors are closed.
Note: Replace loose items/fittings back into
the appliance and leave for at least 15
minutes before switching back on.
1
3
4
6
5
2
7
8
2
3
1
Vista de página 12
1 2 ... 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários