Hotpoint BS89EK Instruções de Utilização descarregar pdf (Página 3)

TABLE OF CHARACTERISTICS

Dimensions

width 43.5 cm

height 32 cm

depth 40 cm

Volume

56 l

Electrical

connections

voltage: 220 - 240 V~ 50/60Hz

maximum power absorbed 2800 W

(see data plate)

ENERGY

LABEL

Directive 2002/40/EC on the label of

electric ovens. Standard EN 50304

Energy consumption for Natural

convection – heating mode:

Conventional

Declared energy consumption for

Forced convection Class – heating

mode: Pastries

This appliance conforms to the

following European Economic

Community directives: 2006/95/EEC

dated 12/12/06 (Low Voltage) and

subsequent amendments –

2004/108/EEC dated 15/12/04

(Electromagnetic Compatibility) and

subsequent amendments -

93/68/EEC dated 22/07/93 and

subsequent amendments.

2002/96/EC and subsequent

amendments.

1275/2008 stand-by/off mode.

Electrical Connection

Electrical connection

The electrical connection to the mains must be made

on the appliance. The power voltage and frequency

are as indicated on the rating plate.

! THIS APPLIANCE MUST BE EARTHED.

Connecting the power supply cable

To open the terminal board:

 Using a screwdriver, press on the tabs situated

on each side of the terminal board cover.

 Pull open the terminal board cover.

To connect the power supply cable, proceed as

follows:

_ Unscrew the cable clamp screw and the contact

screws L-N-$.

 Fasten the wires beneath the screwheads using

the following colour scheme: Blue (N) Brown (L)

Yellow-Green $

 Fasten the power supply cable in the

corresponding cable clamp and close the cover.

Electrical Connection:

Voltage Frequency: 230

V-1+N 50Hz

Fuse Section: 16A

Supply cable:

3x1.5mm

You can connect your oven to the system means of

a terminal board. Refer to above information for the

minimal cable sections and the calibration of the

protective elements according to the connection.

If the appliance is installed with a junction box, an

omnipolar circuit breaker - with a minimum contact

opening of 3mm - should be installed between the

appliance and the mains.

Power cable supply connection to the electrical

mains:

We recommend you use a power supply cable which

is long enough to allow you to take the oven out of

its recess in the event of maintenance operations

(only use HAR - H 05 - RRF quality cables fitted with

a plug conforming to the regulations in force.

The plug must be accessible at all times.

Unpl ug t he appliance before all operations, even

when replacing the oven lamp.

Using the appliance without correct earthing is

highly dangerous.

! After connecting the appliance

to the flexible

cable, tighten all the screws on the terminal

board.

1 2 3 4 5 6 7 8 ... 11 12

Comentários a estes Manuais

Sem comentários

Hotpoint BS89EK Instruções de Utilização Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Fornos Hotpoint BS89EK