Hotpoint CH60ETC S Instruções de Utilização descarregar pdf (Página 5)

INSTALLATION

WARNING - THIS APPLIANCE MUST BE EARTHED.

Mains Connection

Your cooker should have been checked to ensure that the voltage corresponds with your supply voltage, this is

stated on the rating plate, which is situated on the outer rear panel.

The model number and serial number are located on the front of the cooker, as shown on the Feature's page.

The cooker must be connected by a competent person such as one who is a, NICEIC registered contractor to a

suitable double-pole control unit with a minimum rating of 32A and a minimum contact clearance of 3mm

(applicable to newer properties, older properties where a 30A double pole control unit and a minimum contact

clearance of 3mm is acceptable).

The double pole control unit should be fitted adjacent to the cooker, in accordance with IEE regulations. The

control unit must be within 2 metres of but not directly above the appliance and should be easily accessible in

the event of an emergency.

The power supply cable should conform to B.S.6004 with a conductor size of 6mm2, minimum.

Access to the mains terminals is gained by removing the rear access cover. The mains cable must pass

through the cable clamp adjacent to the terminal block. Sufficient cable should be used to allow the cooker to

be pulled out for servicing.

Ensure that the mains cable is routed away from any brackets affixed to the rear panel and is not

trapped to the rear wall when pushing the cooker into position between cabinets.

Levelling

Four feet are fitted which can be adjusted up or down to set the height (900mm - 930mm) and level the cooker.

The feet can be simply screwed in or out to lower or raise the cooker.

After the correct height is achieved, lock the feet into position by tightening the locking nut using an open

ended spanner.

CAUTION:CAUTION:

CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully.

NOTE:NOTE:

NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves.

Siting the Cooker

The cooker is designed to fit between kitchen cabinets spaced 600mm apart. The space either side need only

be sufficient to allow withdrawal of the cooker for servicing and cleaning.

It can be used with cabinets one side or both as well as in an angled corner setting. It can also be used

freestanding.

Adjacent side walls which project above hob level, must not be nearer to the cooker than 150mm and should be

protected by heat resistant material. Any overhanging surface or cooker hood should not be nearer than 650mm.

Note: This appliance must NOT be fitted on a platform.

Safety Chain

! In order

to prevent

accidental

tipping of the

appliance, for

example by

a child clim-

bing onto the

oven door, the

supplied safety

chain MUST be

installed!

The cooker is fitted with a safety chain to be fixed by

means of a screw (not supplied with the cooker) to

the wall behind the appliance, at the same height as

the chain is attached to the appliance.

Choose the screw and the screw anchor according

to the type of material of the wall behind the applian-

ce. If the head of the screw has a diameter smaller

than 9mm, a washer should be used. Concrete wall

requires the screw of at least 8mm of diameter, and

60mm of length.

Ensure that the chain is fixed to the rear wall of the

cooker and to the wall, as shown in figure, so that

after installation it is tensioned and parallel to the

ground level.

1 2 3 4 5 6 7 8 9 10 ... 35 36

Comentários a estes Manuais

Sem comentários

Hotpoint CH60ETC S Instruções de Utilização Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Micro-ondas Hotpoint CH60ETC S